Remco's Drive Shaft Coupling

Prevents automatic transmission damage to your rear-wheel drive vehicle.

With Remco's Drive Shaft Coupling you now have a simple and convenient way to tow your rear-wheel drive automatic transmission vehicles. No more having to have your car mechanically serviced to disconnect your drive shaft from the rear axle. There's no worry about damaging your transmission. To drive your vehicle, a simple push in on the control knob and you are ready to go.

Remco's Drive Shaft Coupling

Need help? Download REMCO DRIVE SHAFT MEASUREMENT GUIDELINES

Ordering by fax? Download REMCO DRIVE SHAFT MEASUREMENT SHEETS

Features

No transmission damage while towing.
No speedometer miles are accumulated while towing.
Shift to drive or tow in seconds.
Coupling made with heat treated alloy steel.
Precision cut gear teeth.
Lifetime sealed ball bearings.
Fits most rear wheel drive cars, vans or pickups.
Purchase with new shaft attached or have car's shaft reworked.
Over 150,000 units on the road in 25 years.
Complete step-by-step installation instructions.
Easy installation by a garage or a weekend mechanic.
One year limited warranty.

No mileage accumulation on the odometer, no wear and tear on the drive line, plus you can tow your vehicle on all four wheels without the need a dolly. All these benefits from a patented system that a mechanic can install in approximately 3 hours.

Detailed Information

When you tow your rear-wheel drive car, van, pickup or SUV, the drive shaft to the rear axle must be disconnected to prevent damage to the automatic transmission. This requires mechanical service under the car which is not convenient for RV towing. REMCO's Drive Shaft Coupling was developed to provide a quick and easy means of disconnecting the transmission while sitting in the driver's seat. The coupling (mechanical clutch) is installed into the rear portion of the vehicle's drive shaft, near the rear axle.

When disconnected, the rear axle is free to turn without turning the drive shaft or transmission. The coupling has a control cable attached to it which extends to a location under the driver's seat. This control cable is pulled out to disengage for towing and pushed in to engage for driving the car.

Let REMCO custom build a new replacement drive shaft with coupling for you. In most cases we can balance your drive shaft at the factory. However, there are some vehicles where we don't have access to aftermarkets parts and therefore cannot balance those drive shafts. Those drive shafts are indentified as "SKU-1" and "SKU-2" drive shafts. These drive shafts are "trued", but not "balanced". Prices start at $750.00. Call 1-800-228-2481 for details on application or click here to use our Online Vehicle Chart..